Edge-Core EWS4502 Guide d'installation Page 30

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 51
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 29
Chapter 4
| Power and Grounding
How to Install the Power Injector
– 30 –
Note
:
Use cable strips to secure all cables to the pole.
How to Install the Power Injector
The power injector can be installed indoors on any horizontal surface, such as a
desktop or shelf, or on a wall.
Caution
:
Do not install the power injector outdoors. The unit is for indoor
installation only.
Caution
:
Install lightning protection at the power injector end of the Ethernet
cable, use a lightning arrestor immediately before the cable enters the building.
Figure 18: Connecting the Power Injector
1. Connect outdoor-rated Ethernet cable from the AP to the RJ-45 port labeled
“DATA & POWER OUT” on the power injector.
2. Connect a straight-through unshielded twisted-pair (UTP) cable from a local
LAN switch to the RJ-45 port labeled “DATA IN” on the power injector. Use
Category 5e or better UTP cable for 10/100/1000BASE-T connections.
AC Power Cord DATA & POWER OUT Port
DATA IN Port
1
2
3
1
3
2
Vue de la page 29
1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 50 51

Commentaires sur ces manuels

Pas de commentaire