Edge-Core RG230 Guide de l'utilisateur télécharger pdf (Page 97)

C-1

Appendix C: Cables and Pinouts

Twisted-Pair Cable Assignments

For 10/100BASE-TX connections, a twisted-pair cable must have two pairs of wires.

Each wire pair is identified by two different colors. For example, one wire might be

green and the other, green with white stripes. Also, an RJ-45 connector must be

attached to both ends of the cable.

Caution: Each wire pair must be attached to the RJ-45 connectors in a specific

orientation. (See “Straight-Through Wiring” on page C-2 and “Crossover

Wiring” on page C-2 for an explanation.)

Caution: DO NOT plug a phone jack connector into the RJ-45 port. Use only twisted-pair

cables with RJ-45 connectors that conform with FCC standards.

The following figure illustrates how the pins on the RJ-45 connector are numbered.

Be sure to hold the connectors in the same orientation when attaching the wires to

the pins.

Figure C-1 RJ-45 Connector

10/100BASE-TX Pin Assignments

Use unshielded twisted-pair (UTP) or shielded twisted-pair (STP) cable for RJ-45

connections: 100-ohm Category 3 or better cable for 10 Mbps connections, or

100-ohm Category 5 or better cable for 100 Mbps connections. Also be sure

that the

length of any twisted-pair connection does not exceed 100 meters (328 feet).

The RJ-45 ports on the unit supports automatic MDI/MDI-X operation, so you can

use straight-through or crossover cables for all network connections to PCs,

switches, or hubs. In straight-through cable, pins 1, 2, 3, and 6, at one end of the

cable, are connected straight through to pins 1, 2, 3, and 6 at the other end of the

cable.

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 115 116

Pas de commentaire

Edge-Core RG230 Guide de l'utilisateur Page 97